Table of Contents
Advertisement
English
LD-G-6
Performing a visual check
Damaged materials can cause injury. Parts damaged during transit can
also be dangerous.Check the module for damage, missing parts or poor
soldering. If you find damage, return the module for exchange.
Mounting the locomotive decoder
Open the locomotive housing. Locate the position for the decoder. Take
into account the room needed for the heat sink, if necessary.
Disconnect the motor from the rail current collector respectively the
change-over switch from the motor and rails if you have a locomotive
with electronic change-over switch.
!
Caution:
The interference suppression devices mounted to the motor or the
connecting wire must not be removed! Motor and interference
suppression devices are one unit. If even one part is removed, it can
cause extreme interference!
Connecting
Follow the connections diagrams (fig. 1a and 1b)!
Solder the connections to the rails at points X1 and X2 and the
connections to the motor at the points X11 and X12.
Connecting the lighting
Follow the connections diagrams (fig. 1a and 1b)!
Disconnect any existing diodes in the leads to the lamps. Connect the
lamps for forward motion to X4 and the lamps for reverse to point X5.
If the lamps are already connected with one side to locomotive ground,
you should solder a diode between the decoder and the lamp (fig. 1b).
If not, connect the second side of the lamps to the return conductor
(point X3) according to fig. 1a.
Page 30
Advertisement
Table of Contents
