Toyota GR Supra Owner's Manual page 239

3
Locate and press the syn-
chronizing button on the sys-
tem being programmed, e.g.
at the garage gate. You have
approx. 30 seconds for the
next step.
4
Hold down the programmed
button on the interior mirror
for approximately 3 seconds
and then release it. If neces-
sary, repeat this step up to
three times in order to finish
synchronization. Once syn-
chronization is complete, the
programmed function will be
carried out.
Reprogramming individ-
ual buttons
1
Switch on standby state.
2
Press and hold the interior
mirror button to be pro-
grammed.
3
As soon as the LED on the
interior mirror flashes orange
after approx. 20 seconds,
release the button.
4
Hold the hand-held transmit-
ter for the system to be used
approx. 1 to 12 in/2.5 to 30
cm away from the buttons on
the interior mirror. The
required distance depends
on the hand-held transmitter.
5
Press and hold the button of
the desired function on the
hand-held transmitter.
Canada: if programming with the
Supra Owner's Manual
4-1. CONTROLS
hand-held transmitter was inter-
rupted, hold down the interior mirror
button and repeatedly press and
release the hand-held transmitter
button for 2 seconds.
6
The LED can light up in dif-
ferent ways.
 The LED lights up green: the
programming procedure is
completed.
Release the button.
 The LED flashes fast: the
hand-held transmitter was
detected but programming is
not complete.
Press the button on the interior mir-
ror for 2 seconds and release. Per-
form this procedure three times to
complete the programming proce-
dure.
If the universal remote control
remains nonoperational, continue
with the special features for change
code wireless systems.
 LED does not flash green
after 60 seconds: program-
ming not completed.
3 6
to
Repeat steps .
If the programming procedure is
not completed, the previous pro-
gramming will remain
unchanged.
239
4