Setting An Indoor Unit Address And Installation Option - Samsung AM FN1DEH Series Installation Manual

Setting an indoor unit address and installation option

Set the indoor unit address and installation option with remote controller option.
Set the each option separately since you cannot set the ADDRESS setting and indoor
unit installation setting option at the same time. You need to set twice when setting
indoor unit address and installation option.
The procedure of option setting
MR-DC00, MR-DH00
Entering mode
for setting option
High Temp
Button
Low Temp
Button
Step 1. Entering mode to set option
1. Remove batteries from the remote controller.
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button.
3.
Step 2. The procedure of option setting
After entering the option setting status, select the option as listed below.
Option setting is available from SEG1 to SEG 24
SEG1, SEG7, SEG13, SEG19 are not set as page option.

Set the SEG2~SEG6, SEG8~SEG12 as ON status and SEG14~18, SEG20~24 as

OFF status.
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
0 X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2 X X
Option
setting mode
Mode
change
High Fan
Button
Low Fan
Button
Check if you have entered the option setting status.
X X X 1 X X
X X X 3 X X
MR-EC00, MR-EH00
Entering mode
for setting option
High Temp
Button
Low Temp
Button
On(SEG1~12)
X X X
X X X
Option
setting mode
Mode
change
High Fan
Button
Low Fan
Button
Off(SEG13~24)
25