Setting An Indoor Unit Address And Installation Option - Samsung AM022 NMD Series Installation Manual

Setting an indoor unit address and installation option

Set the indoor unit address and installation option with remote controller option.
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting option at
the same time. You need to set twice when setting indoor unit address and installation option.
The procedure of option setting
Turns the air conditioner on or off.
Adjusts the temperature.
Selects options during operation.
Sets timer option.
Moves to select and set an option.
Step 1. Entering mode to set option
1. Remove batteries from the remote controller.
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button.
3.
Check if you have entered the option setting status.
Step 2. The procedure of option setting
After entering the option setting status, select the option as listed below.
Option setting is available from SEG1 to SEG 24
• SEG1, SEG7, SEG13, SEG19 are not set as page option.
CAUTION
• Set the SEG2~SEG6, SEG8~SEG12 as ON status and SEG14~18, SEG20~24 as OFF status.
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6 SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
0 X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2 X X
Power
Temperature
Options
Timer
Direction
X X X 1
X X X 3
Air flow direction (Up and down)
Adusts the air flow direction up and down
(Not applicable to Duct type models).
Mode
Selects operation mode.
Fan speed
Adjusts the fan speed.
Air flow direction (Left and right)
Adjusts the air flow direction left and right.
Settings
Selects settings.
SET
Selects or cancels an option.
X X X X X
X X X X X
On(SEG1~12) Off(SEG13~24)
35