Samsung AM FN1DEH Series Installation Manual page 23

How to connect your extended power cables
1 Prepare the following tools.
Tools Crimping pliers
Spec
Shape
2
As shown in the figure, peel off the shields from the rubber and wire of the power
cable.
- Peel off 20 mm of the wire shields of the tube.
• After peeling off the tube wire, you must insert a contraction tube.
• For information about the power cable specifications for indoor and
CAUTION
outdoor units, refer to the installation manual.
3
Insert both sides of core wire of the power cable into the connection sleeve.
f Method 1
f
Push the core wire into the sleeve from both sides.
f Method 2 f
Twist the wire cores together and push it into the sleeve.
4
Using a crimping tool, compress the two points and flip it over and compress another two points in the same location.
- The compression dimension should be 8.0.
- After compressing it, pull both sides of the wire to make sure it is firmly pressed.
Compression
dimension
Connection sleeve
(mm)
MH-14 20xØ6.5(HxOD)
f Method 1
f
Compress it 4 times.
Contraction tube
Insulation tape
Width 19mm 70xØ8.0(LxOD)
Power cable
f Method 2
f
5 mm
(mm)
20 20 20
60
120
180
(Unit: mm)
Connection sleeve
Connection sleeve
Compress it 4 times.
5 mm
23