Samsung AM FN1DEH Series Installation Manual page 29

Setting an indoor unit installation option (suitable for the condition of each installation location)
1.
Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional power
supply in the indoor unit.
2. The panel(display) should be connected to an indoor unit to receive option.
3.
Set the installation option according to the installation condition of an air
conditioner.
- The default setting of an indoor unit installation option is
"020010-100000- 200000-300000".
- Individual control of a remote controller(SEG20) is the function that controls an
indoor unit individually when there is more than one indoor unit.
4. Set the indoor unit option by wireless remote controller.
 02 series installation option
SEG1 SEG2
0
SEG7 SEG8
1 Drain pump
SEG13 SEG14
2 External control
SEG19 SEG20
Individual control of a
3
remote controller
 1WAY/2WAY/4WAY MODEL : Drain pump(SEG8) will be set to 'USE + 3minute delay' even if the drain pump is set to 0.
 1 WAY/2WAY/4WAY,DUCT MODEL : Number of hours using filter(SEG18) will be set to '1000hour' even if the SEG18 is set to
 When setting the option other than above SEG values, the option will be set as "0".
 SEG5 central control option is basically set as 1 (Use), so you don't need to set the central control option additionally.
However, if the central control is not connected but it doesn't indicate an error message, you need to set the central control
option as 0 (Disuse) to exclude the indoor unit from the central control.
 The output of hot water heater in SEG9 is generated from the hot coil part of the terminal board in duct models.
F1 F2
V1 V2
COM1 (+) (-)
OUTDOOR
DC 12 V
COMMUNICATION
 The external output of SEG15 is generated by MIM-B14 connection. (Refer to the manual of MIM-B14.)
SEG3
2 -
SEG9
Hot water heater
SEG15
External control output
/ External heater On or
Off signal
SEG21
Heating setting
compensation /
Removing condensated
water in heating mode
exept for 2 or 6.
F3 F4 1(L) 2(N) 1
2
COM2 L N
Wire Remote AC HOT
Controller POWER COIL
SEG4
External room
temperature sensor
/ Minimizing fan Central control
operation when
thermostat is off
SEG10 SEG11
EEV Step when
-
heating stops
SEG16 SEG17
S-Plasma ion Buzzer
SEG22 SEG23
EEV Step of
stopped unit during
Motion detect sensor
oil return/defrost
mode
* The output of hot coil terminal is AC 220 V / 230 V
(The same as Indoor Unit's input Power)
Indoor Unit
1(L)
F2
2(N) F1
SEG5 SEG6
FAN RPM
compensation
SEG12
-
SEG18
Number of hours using
filter
SEG24
-
29