ConnectAudioSwitchAndAoipPortsToTheCore - Calrec TYPE R Installation Manual

The default IO box and core AoIP network interface
settings are shown in the table above right:
All IO box, core AoIP network interfaces and Connect
server AoIP interfaces must have unique IP addresses,
so if multiple AoIP devices in the same IO box type or
multiple cores need to be connected, it is essential that
all IP addresses are reconfigured accordingly first.
Important:Currently,theIPaddressesand
subnetmasksassignedtothecore'sConnect
serverarefixed.Itwillbepossibletoeditthese
settingsfromsoftwarereleasev1.2.
Untilthen,allAoIPdeviceswhicharetobe
discoveredandcontrolledbyConnectmust
resideinthe192.168.30/24(Primary)and
192.168.31/24(Secondary)subnets.
14. CONNECT AUDIO SWITCH AND AOIP PORTS TO THE CORE
1. Connect the audio network switch(es) to interfaces 5 (& 6) on the rear of the core (marked "Surface") ,
Then follow the steps given below to configure each AoIP interface in an IO box or core:
2. Connect the Pri & Sec AoIP interfaces on the rear of the IO box or core, to your network switch or switches.
Note: Follow the suggested switch port connections given for your network switch(es) in the corresponding Network
Device document if unsure (see section 5).
Note: PTP aware switches are recommended, but are not necessary for small AoIP networks
Note: Connect one IO box / device or core at a time to avoid IP address conflicts.
EXAMPLE OF CONNECTING A COMBO AOIP BOX TO THE CORE VIA AN AOIP SWITCH
IO BOX & CORE AOIP NETWORK INTERFACE SETTINGS
Box type /Core
Primary core
Connect Server
Combo
Analogue
AES
Primary Core AoIP1
Secondary Core AoIP2
AoIP port IP address & Subnet mask**
Pri (I/F 5) 192.168.30.100/24
Sec (I/F 6) 192.168.31.100/24
AoIP - Pri 192.168.30.1/24
AoIP - Sec 192.168.31.1/24
AoIP - Pri 192.168.30.2/24
AoIP - Sec 192.168.31.2/24
AoIP - Pri 192.168.30.3/24
AoIP - Sec 192.168.31.3/24
AoIP 1 - Pri 192.168.30.4/24
AoIP 1 - Sec 192.168.31.4/24
AoIP 2 - Pri 192.168.30.64/24
AoIP 2 - Sec 192.168.31.64/24
25