AccessAssistSetupAndCreateANewShow; ConnectToAssistFromTheStudioOrManagementSubnets - Calrec TYPE R Installation Manual

8. ACCESS ASSIST SETUP AND CREATE A NEW SHOW
To create a new Show follow these steps:
1. Open Google Chrome, type 172.16.255.25 into the address bar and press enter to navigate to the Assist
landing page.
2. In the menu on the left-hand side, navigate to Shows&snapshots then Shows in the sub-menu.
3. In the footer menu select New, the CreateaShow dialogue will be displayed.
Select the Default_Show template show and click Next.
4. Fill in the form to label and describe your Show, then click CreateNewShow.
You will be automatically redirected to the Faderlayout screen.
5. From here you may begin to configure your mixer with DSP paths, routing etc.
However we would recommend that you continue to complete the setup before doing this.
Please refer to the Type R Assist Manual or Type R Assist and Console Operation Manual for more guidance.
9. CONNECT TO ASSIST FROM THE STUDIO OR MANAGEMENT SUBNETS
Assist may be accessed via the front-facing
port may not be connected to a local area network (LAN) and in a studio install scenario may not therefore be readily accessible to
an operator or engineer's PC. It is therefore recommended that the PC accessing Assist is now connected to the network switch
that serves the surface panels instead. By default, all user interfaces may be accessed via the rear network interfaces, using either
a "Management" or a "StudioA" subnet. The "Management" subnet resides in the
access to all applications and services running on the core. The "StudioA" subnet resides in the 172.17/16address space
and provides access to the Assist, CoreConfigure & CalrecConnectapplications, as well as the console control service.
Note: Type R is designed to support a Touch Interface if the PC provides this.
To use either subnet configure your PC's ethernet adaptor as follows:
•Management-IPaddress172.29.0.1,subnetmask255.255.0.0
•StudioA-IPaddress172.17.0.1,subnetmask255.255.0.0
Note: Default "Studio B" and "Studio C" subnets will be added in a later version
Assist, CoreConfigure & CalrecConnectapplications
To access the
corresponding IP address shown in the table below into the Google Chrome address bar address bar.
IP ADDRESSES FOR ACCESS TO ASSIST, CONNECT, SOFTWARE UPDATER & CONFIGURE USER INTERFACES
Application
Assist
Calrec Connect
Software Updater
Configure
Setup port by navigating to 172.16.255.25in Google Chrome, however the Setup
Setup Port
(front of core)
172.16.255.25
172.16.255.60
172.16.255.40
172.16.255.19
172.29/16
, from the various connection points in the system type the
Management subnet
(back of core)
172.29.1.1
172.29.1.21
172.29.1.22
172.29.1.23
address space and provides
Studio A subnet
(surface panels)
172.17.1.1
172.17.1.21
172.17.1.22
172.17.1.23
21