ConnectSurfaceSwitch&SurfacePanelsToTheCore - Calrec TYPE R Installation Manual

7. CONNECT SURFACE SWITCH & SURFACE PANELS TO THE CORE
1. To establish communication between the surface panels and the core, connect the network switch to network interface
connections 1 and / or 2 on the rear of the core (marked "Surface"), then connect the surface panels / POE injectors
to the network switches one by one to power them up into "Configuration Mode". Note: If two switches are in use, you may
connect the first to interface #1 and the second to interface #2. Once setup the Core should be rebooted via the Reset button
on the front of the core.
2. If the Core has been configured with a surface layout that matches the connected panels, the panels will be discovered by the
core. If the panels are running a different software version to the core they will automatically update. Once all updates
are completed the panels will boot into"Normal Operating Mode".
Soft panels will display the message "Thispanelhasnolayoutassociatedwiththisshow" and
Fader panels will show blank controls with "NoPath" on each of the lower displays. If any of the panels are displaying
connection errors or "Looking for core" double check the ID matches the surface layout and the IP address is unique.
SURFACE PANEL CONFIGURATION EXAMPLE
20 TYPE R
Radio Production System
Start Up Guide