ConfigureTheCoreForSurfacePanels - Calrec TYPE R Installation Manual

4. CONFIGURE THE CORE FOR SURFACE PANELS
1. In CoreConfigure, navigate to the
ControlSurfaces page. See above right.
2. Select MixerA–SurfaceA.
The surface may now be renamed using
the text entry field at the top of the screen.
3. To add a fader panel select Addfader
panel. This will open the Addfader
paneldialogue. See middle right.
4. Set the type to Faderpanel.
Note: If you do not have a fader panel,
select Virtualpanel.
5. Set the PanelID to match the switches
on the rear of the panel.
Tip: Use the Panel ID switch tool in the
UI to match the switches on the rear of
the panel. Also see "SurfacePanels-SuggestedSettings"
onpage28 for recommended Panel ID's.
6. Set the fader range to 1–6 then click Add.
7. Continue to add fader panels in the same way, with unique panel
IDs and fader range values, until all required fader panels are
added to the surface layout.
8. To add a Soft Panel select Addancillarypanel. This will
open the Addancillarypaneldialogue. See below right.
Note: Where there are multiple fader panels, multiple Add
ancillarypanelbuttons will be available. This is to allow you
to position the panel in the surface layout in a way that roughly
matches your intended surface setup and will also facilitate the
creation of user sections later. The position chosen does not
determine the functionality available to the soft panel.
Up to 8 soft panels may be added per fader section, up to a
maximum of 26 soft panels per core system.
9. Select the type of panel, LSP or SSP.
10. Set the PanelID to match the switches on the rear of the panel.
Tip: Use the Panel ID switch tool in the UI to match the switches
on the rear of the panel.
11. Give the panel a label (e.g. LSP 1, SSP 1, Guest 1), then click
AddPanel.
12. When all surface panels are added to the layout, click Save in
the footer of the control surfaces page.
13. Restart the core from the reset button on the front of the core for
the changes to take effect.
16 TYPE R
Radio Production System
CORE CONFIGURE CONTROL SURFACES PAGE
ADD FADER PANEL DIALOGUE PAGE
ADD ANCILLARY PANEL DIALOGUE PAGE
Start Up Guide