1St Layer Setting Procedures; Control Low Limit Value Setting; Control High Limit Value Setting - Lutron Electronics CT-2012 Operation Manual

4-2 1st layer setting procedures

CtLo
CtHi
ALLo
ALHi
a. Control Low limit value setting
1) Press the " Set Button " ( 3-4, Fig. 1 ) once, the
" Display " will show " CtLo ", now the meter is ready
for the " Control Low limit value " setting.
▼
2) Use the "
Button " ( 3-6, Fig. 1 ) to adjust the desiring " Control
Low limit value ", press the " Set Button " ( 3-4, Fig. 1 )
to save the setting value.
Remark :
* During adjust the value, the " SV indicator " ( 3-3, Fig. 1 )
will light.
* The function of " Control Low limit value " setting, refer to
page 11, Fig. 3.
b. Control High limit value setting
1) After finish above " Control Low limit value setting ",
press the " Set Button " ( 3-4, Fig. 1 ) once, the
" Display " will show " CtHi ", now the meter is ready
for the " Control High limit value " setting.
▼
2) Use the "
Button " ( 3-6, Fig. 1 ) to adjust the desiring " Control
High limit value ", press the " Set Button " ( 3-4, Fig. 1 )
to save the setting value.

Control Low limit value setting

Control High limit value setting

Alarm Low limit value setting
Alarm High limit value setting
Button " ( 3-5, Fig. 1 ) and the "
Button " ( 3-5, Fig. 1 ) and the "
7
▲
▲