Table of Contents
Advertisement
gateway device. The NI-WSN software is supported by Windows 7/Vista/XP and contains the following
components:
•
NI MAX
•
NI-WSN
You can download a current version of NI-WSN software from
browser, go to
Networks, and then select the latest version of NI-WSN software. If you are using other software, refer
to the installation instructions that accompany your software.
What You Need to Get Started
To set up and use NI LabVIEW with the NI WSN-3226 device, you need the following:
•
NI WSN gateway
•
NI WSN-3226 device(s) with a 5–30 V power supply or four alkaline or lithium AA 1.5 V batteries
for each node. Refer to the
•
Mounting hardware (DIN rail, panel-mount, or rack mount accessory)
•
Ethernet cable/connection
•
1/8 in. flathead and number 2 Phillips screwdrivers
•
NI-WSN software version 1.2 or later
•
Host PC running Windows 7/Vista/XP or LabVIEW Real-Time
•
NI LabVIEW 2010 (32-bit) or later
•
(NI 9792 WSN Real-Time Gateway Only)
later
•
Related hardware and software documentation
Unpack the Device and Install the Antenna
Remove the device from the package and inspect the device. Contact NI if the device appears damaged.
Do not install a damaged device.
Caution
The device is static sensitive. Always properly ground yourself and the equipment when
handling or connecting to the device.
To attach the antenna, align the antenna with the mount and screw it on, as shown in Figure 3.
Caution
The antenna must be attached to the NI WSN device in order for the NI WSN device to
function correctly.
© National Instruments Corporation
and select Drivers and Updates»Distributed I/O»Wireless Sensor
ni.com/support
Battery Power
ni.com/support
section for recommended battery types.
—NI LabVIEW 2009 SP1 (32-bit) Real-Time Module or
5
. Using your Web
NI WSN-3226 User Guide and Specifications
Advertisement
Table of Contents
