Table of Contents
Advertisement
Mounting the NI WSN-3226 Device
You can mount the NI WSN-3226 on a panel or on a 35 mm DIN rail. For kit accessory ordering
information, refer to the NI WSN product page accessory section at
mounting methods, remove and save the serial number sticker located on the back of the NI WSN-3226
device for future use when configuring your device in software. For the NI WSN-3226 device
dimensions, refer to Figure 2.
Caution
Your installation must allow 50.8 mm (2 in.) of clearance in front of devices for common
connector cabling, such as the 18-terminal detachable screw terminal connector.
Attaching the NI WSN-3282 DIN Rail (Optional)
You can mount the NI WSN-3226 on a standard 35 mm DIN rail using a NI WSN-3282 DIN rail clip,
NI part number 781074-01. Complete the following steps to mount the NI WSN-3226 on a DIN rail:
Caution
Power off the device before mounting it to the DIN rail.
Note
Use thread-forming screws to permanently affix the DIN rail clip to the device. Unscrewing
and reinstalling the thread-forming screws will produce a compromised connection between the DIN
rail clip and the device.
1.
Fasten the DIN rail clip to the NI WSN-3226 using a number 2 Phillips screwdriver and the
four 8-32 × 5/16 in. thread-forming screws that shipped with the DIN rail clip(s). Figure 4 shows
how to fasten the DIN rail clip to the NI WSN-3226.
Caution
Do not use screws longer than 5/16 in. to fasten the DIN rail clip to the NI WSN-3226.
NI WSN-3226 User Guide and Specifications
Figure 3. Attach the Antenna to the Device
6
NATIONAL
INSTRUMENTS
. Before using any of these
ni.com
ni.com
Advertisement
Table of Contents
