Section 8. Troubleshooting; Error Codes; Deleting An Error Code - Zodiac CX40 Owner's Manual

Section 8. Troubleshooting

If the status indicator on the Control Unit flashes to alert the user, follow the recommended
troubleshooting tips below.
8.1

Error Codes

Flashing LED
1 flash / 1 second pause
2 flashes / 1 second pause
Rapid flashing
Rapid flashing
3 flashes / 1 second pause
Rapid flashing
8.2

Deleting an error code

After following the troubleshooting solutions, press any key to delete the error code.
Page 14
• Disconnect and reconnect the cleaner.
• Check that the cable is properly connected to the control box.
• Check that nothing is interfering with the cable connection area.
• If this does not resolve the problem, contact your local retailer for a diagnostic review or call
customer service.
• Check that debris or the cable is not preventing the brushes or the tracks from rotating freely.
• Check that nothing is interfering with the cable connection area.
• Rotate the track by a quarter of a turn in the same direction until it rotates smoothly
• If this does not resolve the problem, contact your local retailer for a diagnostic review or call
customer service.
• Turn the cleaner off.
• Clean the filter thoroughly.
• Put it back in the water, shaking to release the air bubbles.
• Restart the cycle.
• If this does not resolve the problem, contact your local retailer for a diagnostic review or call
customer service.
• Check that no debris or hair is blocking the impeller.
• Clean the filter thoroughly.
• If this does not resolve the problem, contact your local retailer for a diagnostic review or call
customer service.
Zodiac
Suggested Solution
Robotic Cleaner | Owner's Manual
®