Cable Assembly - Weider 831.153933 User Manual

16. Press a 1 1/2" x 2" Inner Cap (21) into the Right
Butterfly Arm (26). Wet the lower end of the Arm with
soapy water. Slide a Long Pad (54) onto the Arm.
Slide two Nut Clips (108) onto a Press Handle (27).
Attach the Press Handle to the Right Butterfly Arm
(26) with two 5/16" x 3/4" Button Head Screws (51).
Slide the Long Pad (54) down so that the bottom is
flush with the lower end of the Arm. Press a 1"
Round Inner Cap (29) into the Press Handle. Wet
the Press Handle with soapy water. Slide a Long
Handgrip (28) onto the Press Handle.
Lubricate a 3/8" x 2" Bolt (100) with grease. Attach
a Pivot Bracket (70) to the Right Butterfly Arm (26)
with the Bolt and a 3/8" Nylon Jamnut (113). Do not
overtighten the Nylon Jamnut; the Pivot Bracket
must be able to pivot easily. Repeat this step
with the Left Butterfly Arm (25).
17. Lubricate a 3/8" x 3" Button Head Bolt (104) and
both sides of two Plastic Washers (56) with grease.
Attach the Right Butterfly Arm (26) to the Butterfly
Frame (47) with the Bolt, the two Plastic Washers,
two Butterfly Caps (57), two 3/8" Washers (91), and
a 3/8" Nylon Jamnut (113) as shown. Make sure
that the recessed sides of the Plastic Washers
are fitted over the welded bushing in the
Butterfly Arm. Do not overtighten the Nylon
Jamnut; the Butterfly Arm must be able to pivot
easily.
Repeat this step with the Left Butterfly Arm (25).

CABLE ASSEMBLY

18.
IMPORTANT: Refer to the Cable Identification
Chart on page 26 for help identifying the
cables. Do not overtighten the bolts and
nuts attaching the pulleys. The pulleys must
be able to turn freely.
Locate and open the parts bags labeled "CABLE
ASSEMBLY" and "PULLEYS."
Lubricate the 3/8" x 7" Bolt (30) with grease. Attach
the Swivel Cage (76) to the Swivel Carriage (46)
with the Bolt and a 3/8" Nylon Locknut (87).
Locate the Swivel High Cable (74), which is 126
1/2" long and has a ball on one end and a
threaded bolt on the other end. Wrap the Cable
around a 3 1/2" Pulley (78). Attach two Pulleys to
the Swivel Cage (76) with two 3/8" x 1 3/4" Bolts
(93) and two 3/8" Nylon Locknuts (87).
16
26
51
54
108
29
27
17
56
26
18
78
74
78
93
76
11
Lubricate
100
70
113
21
25
28
104
91
57
47
57
91
113
30
87
46
87
25