Cable Assembly - Weider WESY99490 User Manual

18. Press a 1 3/4Ó Square Inner Cap (35) into each end
of the Right Butterfly Arm (11). Wet the lower end of
the Arm with soapy water. Slide a Butterfly Foam Pad
(29) onto the lower end of the Arm.
Lubricate the indicated axle on the Butterfly Top
Frame (33). Orient the Right Butterfly Arm (11) as
shown and slide it onto the axle. Secure the Butterfly
Arm with two Retainer Rings (31) and a 1Ó Round
Outer Cap (38). Note: Place the Retainer Rings on
top of the inverted Outer Cap and gently tap the
Cap onto the axle with a hammer. Make sure the
teeth on the Retainer Rings bend towards the Cap
as shown in the inset drawing.
Repeat this step to assemble the Left Butterfly Arm
(10, not shown).

Cable Assembly

19. Locate and open the parts bag labeled ÒCABLE
ASSEMBLY AND PULLEYS.Ó For Cable identifica-
tion and routing during steps 19 to 49, refer to the
Cable Diagrams and Cable ID Chart on pages 23
and 24.
Identify the Butterfly Cable (73). It is approximately
52Ó long and it has a closed loop on each end. Attach
the Butterfly Cable to the bracket on the Left Butterfly
Arm (10) with a 3/8Ó x 1Ó Bolt (84) and two 3/8Ó Nylon
Jamnuts (63). Note: The loop on the Cable and the
two Nylon Jamnuts must be mounted underneath
the welded bracket.
20. Wrap the Butterfly Cable (73) around a ÒVÓ-Pulley
(27) in the direction shown. Attach the ÒVÓ-Pulley and
a Large Cable Trap (32) to the bracket on the back
of the Butterfly Upright (1) with a 3/8Ó x 2 1/2Ó Bolt
(53) and a 3/8Ó Nylon Locknut (50). Make sure the
Large Cable Trap is oriented as shown.
18
11
35
29
19
Bracket
10
20
11
33
Axle
35
31
38
Axle
31
Teeth
38
84
63
73
32
27
50
Bracket
1
53
73