Cable Assembly - Weider Wedier Pro 9635 User Manual

15. See the inset drawing. Attach the Military
Press Arm (84) to the Pivot Arm (101) with
two M8 x 57mm Bolts (33) and two M8 Nylon
Locknuts (3).
Attach the Pivot Arm (101) to the VKR Upright
(74) with an M10 x 83mm Bolt (67) and an
M10 Nylon Locknut (21).
16. Locate and open the parts packets labeled
"CABLE ASSEMBLY" and "PULLEYS."
During steps 16 through 35, refer to the
CABLE DIAGRAMS on pages 26–27 of this
manual to verify proper cable routing. Before
beginning this section, fully unwind the four
Cables. Identify the four Cables by comparing
the lengths and ends of the Cables. The
approximate length of each Cable is listed
after the key number in the drawing.
IMPORTANT: While assembling the cables,
do not overtighten the bolts and nuts
attaching the pulleys. The pulleys must be
able to turn freely.
17. Locate the High Cable (58). Wrap the High
Cable over a 90mm Pulley (15). Attach the
Pulley to the Top Frame (55) with an M10 x
92mm Bolt (88) and an M10 Nylon Locknut
(21). Make sure that the end of the Cable
with the ball is on the indicated side of the
Pulley and that the Cable is between the
Pulley and the hook.
15
21
101
67
74
101
16
17
21
55
Ball
Hook
11
84
56
33
33
84
3
23—79 in.
(2 m)
58—147 in.
(3.73 m)
72—194 in.
(4.93 m)
99—63 in.
(1.6 m)
58
15
88