ROTAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
4. Installation of the Bowden cable for carburetor control
See Fig. 7.
Æ
Carefully remove the carburetor cover and the rubber ring (pos. 7, 8).
¢ Attention: Reset spring (pos. 6) of carburetor slide presses against carburetor cover and might
eject carburetor cover at removal.
Æ
Remove nipple screw (pos. 5) with A/F 10 wrench from carburetor piston (pos. 2).
Æ
Engage nipple of Bowden wire (pos. 9) in nipple screw (pos. 5).
Æ
Fit nipple screw in carburetor piston and tighten with A/F 10 wrench.
Æ
Insert carburetor slide (pos. 2) into carburetor body with recess of slide towards
intake silencer.
Æ
Pass Bowden wire through compression spring (pos. 6) and through cover with
rubber ring (pos. 7, 8) of carburetor.
Æ
Fit carburetor cover (pos. 7) on carburetor.
Æ
Thread Bowden wire through Bowden conduit and through adjustment screw on
chassis.
Æ
Connect Bowden cable to throttle pedal.
¿ Note:
Shorten Bowden cable as required.
Page 10/58
Fig. 7
Edition 09/2016