Prior To Start-Up; Maintenance - Hayward Super II SP3000 ECO Series Owner's Manual

Prior to Start-Up

If it is necessary to perform a water pressure test prior to the initial use to ensure the plumbing system is functioning properly, then the
following criteria should be maintained for this test:
» Have a professional perform this test.
» Ensure all Hayward pump and system components are removed from the system prior to performing the test. However:
WARNING – If circulation equipment must remain in the plumbing system during water pressure test, do not apply more than
68 kPa (10 psi) pressure to the system. Be sure water pressure has been released, using the Filter Manual Air Relief Valve,
WARNING – All suction and discharge valves MUST BE OPEN, as well as the Filter Air Relief Valve (if available) on filter, when
starting the circulating pump system. Failure to do so could result in severe personal injury.
Priming The Pump
Make sure to release all the pressure from the pump and the piping system by using the Filter Manual Air Relief Valve (if available). Close
the valves in the suction and discharge lines and remove the strainer cover. Fill the strainer housing with water to suction pipe level. If water
leakage occurs from anywhere on the pump or filter, DO NOT start the pump. If no leakage occurs re-install the strainer cover and ensure
the Suction, Discharge, and Filter Air Relief Valves are open. Stand at least 2.5 metres from the pump and/or filter and proceed with
starting the pump.
Water acts as a coolant and lubricant for the mechanical shaft seal. Never run the pump dry. Running the pump dry may
damage seals, causing leakage, flooding, and voids warranty. Do NOT add chemicals to pool/spa system directly to the pump
housing or directly in front of the pump suction. Adding undiluted chemicals directly to the skimmer or strainer basket, may
Starting The Pump
To start the pump, make sure all the suction and discharge valves are open, and the Manual Air Relief Valve on the filter is fully open (if
filter has one). Turn the power on at the power point and the pump will start-up and begin priming. Stand back while the pump primes. Due
to system variances like Suction Lift, and the length of the suction line, five minutes is not an unreasonable length of time for priming. Only
close the Filter Manual Air Relief Valve once a steady stream of water (not air or air mixed with water) is discharging from the valve. If the
pump will not start or prime please refer to the troubleshooting section on page nine (9).
The pump is an electrical device and as such should not be disassembled or serviced by anyone other than a Hayward authorised Super II
ECO Service Technician or a qualified electrician. An experienced Pool Service Technician should attend to any other problems that cannot
be corrected by routine maintenance. Below are a few maintenance notes and precautionary steps the Pool Owner and Pool Service
Technician can take to ensure a safe, efficient and prolonged service by the pump.
Clean strainer basket regularly. Do NOT strike the basket to clean it.
»
Hayward pumps have self-lubricating motor bearings and shaft seals. No further lubrication is necessary.
»
Keep the motor clean. Ensure the air vents and fan are free from obstruction to avoid damage. Do NOT use water to hose
»
off the motor.
» Occasionally, shaft seals must be replaced due to wear or damage. Replace with a genuine Hayward seal assembly kit only.
Do NOT use petroleum based lubricants on gaskets, o-rings, or plastic components. Use silicone based lubricants only.
»
» Inspect strainer cover o-ring regularly and replace as necessary. Keep strainer cover o-ring lubricated.
» Tighten the strainer cover lock ring and the union nuts by hand only (no wrenches).
» Never allow the pump to operate without water.
6
START-UP
before removing the pump strainer cover.
CAUTION – Never Operate The Pump Without Water.
damage the pump and voids warranty.

MAINTENANCE

USE ONLY HAYWARD® GENUINE REPLACEMENT PARTS