Hayward Super II SP3000 ECO Series Owner's Manual

Hayward Super II SP3000 ECO Series Owner's Manual

Single speed pump

Advertisement

Quick Links

8
F
E
D
Super II ECO Single Speed Pump
C
To prevent potential injury and to avoid unnecessary service
calls, read this manual carefully and completely.
B
SAVE THIS INSTRUCTION MANUAL
A
Email: sales@hayward-pool.com.au | Website: www.hayward-pool.com.au
8
USE ONLY HAYWARD® GENUINE REPLACEMENT PARTS
7
6
9.458
SP3000 ECO Series
Owner's Manual
7.625
8.635
Hayward Pool Products (Australia) Pty Ltd.
Melbourne-Sydney-Brisbane-Perth
PO Box 4384 | Dandenong South VIC 3164
ABN 66 083 413 414
Sales Contact Ph: 1300POOLS1 Fax: 1300POOLS2
7
6
5
10.392
12.149
8.154
10.017
5
30-LITINSB022RA
4
13.817
18.866
24
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Super II SP3000 ECO Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Hayward Super II SP3000 ECO Series

  • Page 1 SAVE THIS INSTRUCTION MANUAL 10.017 7.625 8.635 18.866 Hayward Pool Products (Australia) Pty Ltd. Melbourne-Sydney-Brisbane-Perth Email: sales@hayward-pool.com.au | Website: www.hayward-pool.com.au PO Box 4384 | Dandenong South VIC 3164 ABN 66 083 413 414 Sales Contact Ph: 1300POOLS1 Fax: 1300POOLS2 USE ONLY HAYWARD®...
  • Page 2: Important Safety Instructions

    If a power failure occurs while the pump is running, it will automatically restart once the power has been restored. USE ONLY HAYWARD® GENUINE REPLACEMENT PARTS...
  • Page 3 In addition to installing two or more suction outlets per pump, follow all national, state, local regulations and » AS 1926.3 Latest Edition. Installation of a vacuum release or vent system, which relieves entrapping suction, is recommended. » USE ONLY HAYWARD® GENUINE REPLACEMENT PARTS...
  • Page 4: Product Dimensions

    UNAUTHORIZED USE, MANUFACTURE, OR REPRODUCTION IN WHOLE OR IN PART IS PROHIBITED. DRAWING, DESIGN, AND OTHER DISCLOSURES A UNAUTHORIZED USE, MANUFACTURE, OR REPRODUCTION IN WHOLE OR IN PART IS PROHIBITED. DRAWING, DESIGN, AND OTHER DISCLOSURES ARE PROPERTY OF: HAYWARD POOL PRODUCTS INSTALLATION WARNING –...
  • Page 5 SEE PART DRAWINGS WEIGHT: 74.44 LBS. COLOR: SEE PART DRAWINGS SCALE: 1:1 SHEET 1 OF 1 STATUS: UNAUTHORIZED USE, MANUFACTURE, OR REPRODUCTION IN WHOLE OR IN PART IS PROHIBITED. DRAWING, DESIGN, AND OTHER DISCLOSURES ARE PROPERTY OF: HAYWARD POOL PRODUCTS...
  • Page 6: Prior To Start-Up

    MAINTENANCE The pump is an electrical device and as such should not be disassembled or serviced by anyone other than a Hayward authorised Super II ECO Service Technician or a qualified electrician. An experienced Pool Service Technician should attend to any other problems that cannot be corrected by routine maintenance.
  • Page 7 » Disconnect the pump motor power cord from the power outlet before beginning the shaft seal replacement. Only qualified personnel should attempt to replace the shaft seal. Contact your local authorised Hayward Dealer or » service center if you have any questions.
  • Page 8: Components & Parts

    SPX1600P SPX1600P HAND KNOB STATUS: COLOR: SEE PART DRAWINGS UNAUTHORIZED USE, MANUFACTURE, OR REPRODUCTION IN WHOLE OR IN PART IS PROHIBITED. DRAWING, DESIGN, AND OTHER DISCLOSURES ARE PROPERTY OF: HAYWARD POOL PRODUCTS SPX1600N SPX1600N SPX1600N SPX1600N SPX1600N COVER SWIVEL NUT...
  • Page 9: Troubleshooting

    Motor Cuts Out Your Hayward pump motor is equipped with Automatic Thermal Overload Protection. The motor will automatically shut-off before heat damage build up can occur due to abnormal operating conditions. The motor will auto-restart when a safe heat level is reached. If the motor fails to restart, switch the power off and contact an authorised Super II ECO Pump Service Technician.
  • Page 10: Technical Information

    19.05 IPX5 SIIE 580 22.7 m - 223 kPa 2.33 10.46 < 70 20.8 IPX5 Flow Curves Super II ECO Performance Curves SIIE 320 SIIE 350 SIIE 430 SIIE 530 SIIE 580 Flow l/min USE ONLY HAYWARD® GENUINE REPLACEMENT PARTS...
  • Page 11: Warranty

    Paying the costs of repairing the Goods. Claims made for warranty, labour or infield support will not be accepted by Hayward Pool Products unless evidence is provided that installation has been completed in accordance with standard warranty conditions. Please refer to specific program document for details.
  • Page 12 Hayward Pool Products (Australia) Pty Ltd. Melbourne-Sydney-Brisbane-Perth Email: sales@hayward-pool.com.au | Website: www.hayward-pool.com.au PO Box 4384 | Dandenong South VIC 3164 Hayward and Super II are ABN 66 083 413 414 registered trademarks of Hayward Sales Contact Ph: 1300POOLS1 Fax: 1300POOLS2 Industries, Inc.

Table of Contents