Assembly And Setup; Adjusting The Footplate - Cocraft Pro Edition JT18-P Original Instructions Manual

Assembly and setup

Note: Always remove the battery from the jigsaw before performing any adjustment,
service or maintenance.
Fitting and replacing the blade
1. Turn the blade clamp to the position
shown in the figure and push the blade
all the way into the clamp.
3. Make sure that the blade runs along the blade guide roller and is securely fastened
in the blade clamp.

Adjusting the footplate

1. The footplate (12) can be tilted
up to 45° to the right or left.
There are fixed settings for 0°
and 45°.
2. Undo the socket head cap
screw holding the footplate
using the included hex key.
3. Slide the footplate forwards and
tilt it to the required angle:
2. Release the blade clamp and check
that it has sprung back to the locked
position shown in the figure.
10
0
0