DAITEM MD500 Installation Notice page 5

E
GB
On the first line, mark the boxes corresponding to the installation
radio code for the control panel (a cross for each opened hole). On
the second line, below each cross, mark a 0. In each empty box,
mark a 1.
installation radio code
medallion code
Example (not to be used): you have broken the connections 2, 7
and 8 on the control panel .
installation radio code
medallion code 1
Caution: For telephone dialers interface with a 10 microswitch bar
for the installation radio code, fill in the 10 boxes on the second line
directly:
with a 1 for a microswitch
in the ON position
with a 0 for a microswitch
in the OFF position
Example (not to be used):
installation radio code
medallion code
You now have a series of ten 0 (press the "0" push button) and 1
(press the "1" push button) for programming the installation radio
code.
8
1 2 3 4 5 6 7
1 2 3 4 5 6 7
X X
0 1 1 1 1 0
O
N
1
O
N
1
O
N
1 2 3 4 5 6 7 8 9 10
1 0 1 1 1 1 0 0 1 1
1 2 3 4 5 6 7
1 0 1 1 1 1 0
Programme the installation radio code by pressing the "0" and "1"
push buttons as shown:
Press both keys
at the same time
until the light goes
8 9 10
out
0
Start customising
Warning: if, during programming, you leave more than 7 seconds
8 9 10
between entries or if you do not press "0" and "1" at the same time
or for long enough, you will quit the programming mode: the red
X
light flashes, the programming is incorrect. Start the customising
0 1 1
procedure again from the beginning.
Allocation of a channel
Choose the channel required from the following table:
Chanel
Alert Call
Silent Alarm
Audible Signal
You now have a series of 2 figures corresponding to the channel
code to be entered.
8 9 10
0 1 1
Type the series of 10
keys corresponding to the
installation radio code
...
1
Channel code Operation
Triggers the sirens, relay and telephone dialer
0 0
interface for 90 secs
Triggers the relay for 90 secs
1 0
Triggers the telephone dialer interface
The sirens are not triggered
4 audible beeps on the control panel
1 1
The sirens and the telephone dialer interface
are not triggered
E
GB
Press both keys at the same
time until the light goes out. The
light then comes on again for 5
seconds to indicate successful
programming
0 1
End of customising
9