Safety; Correct Use; Safety Instructions; Appliance Description - STIEBEL ELTRON SBP 200 E Operation And Installation

operation

safety

2. Safety
2.1

correct use

This appliance is only intended to be used for the storage and
heating of heating water.
The appliances SBP 200 E cool, SBP 400 E cool, SBP 700 E and
SBP 700 E SOL are additionally intended to be used for storing
cooled heating water up to + 7 °C.
Any other or additional use is inappropriate, in particular
usage with alternative storage media. Correct use also includes
observation of the operating and installation instructions. Only
use the appliance for the purpose stated by us and never change
or convert it in any way.
2.2

Safety instructions

Observe the following safety information and instructions.
Installation and commissioning must only be carried out by a
qualified heating contractor.
The heating contractor is responsible for adherence to all currently
applicable regulations during installation and commissioning.
Operate this appliance only if it is fully installed and all safety
equipment is fitted.
Risk of injury
When cleaning the appliance, never use unsuitable
means of access (e.g. stools, chairs, tables). Risk of
a fall.
www.stiebel-eltron.com
3.

Appliance description

3.1

Properties

3.1.1 General
This appliance is designed to extend the operating time of the heat
source and to bridge power-OFF periods. It also enables hydraulic
separation of the volume flow of heat source and heating circuit.
3.1.2 SBP 200 E | SBP 400 E | SBP 200 E cool | SBP 400 E cool
To boost the heating water electrically, the installation of a BGC
electric immersion heater is possible.
3.1.3 SBP 200 E cool | SBP 400 E cool | SBP 700 E | SBP 700 E Sol
These cylinders are equipped with complete thermal insulation to
protect against the formation of condensate.
3.1.4 SBP 700 E
For electric heating of the heating water, the installation of two
BGC electric immersion heaters is possible. Additionally, a solid
fuel boiler may also be connected.
3.1.5 SBP 700 E SOL
The SBP 700 E SOL cylinder is additionally equipped with a smooth
tube heat exchanger for solar heating of the heating water.
sBp e | sBp e sol | sBp e cool | 11