The Most Important Points In Brief; Operation; Safety Information; Important Notes - STIEBEL ELTRON SH 30 S Operating And Installation Instructions

OperatiOn

Operating instrUctiOns
2.2 themostimportantpointsinbrief
1 Temperature selection button
2 Signal lamp for operating mode
3 Lights for the heat content display
4 „SERVICE ANODE" signal lamp
2.3 Operation
Temperature selection button (1)
• = cold (see also Instructions, Risk of Freezing)
E = (approx. 60 °C) Recommended energy economy setting,
low limescale formation
70 °C = Maximum temperature which can be set.
Depending on the system, the temperatures may deviate from the
reference value.
2.4 safetyinformation
Risk of scalding!
There is a risk of scalding at outlet temperatures in
excess of 43 °C.
Risk of injury!
Where children or persons with limited physical, sen-
sory or mental capabilities are to be allowed to control
this appliance, ensure that this will only happen under
supervision or after appropriate instructions by a per-
son responsible for their safety.
Children must be supervised to ensure that they do not
play with the appliance.
The appliance is under mains water pressure.
During heat-up, expansion water drips from the safety
relief valve and the T&P valve. If water continues to
drip when heating is completed or in case of other
malfunctions, please inform your heating contractor
after switching off the heat source and prior to any
further use of the system.
2.5 importantnotes
Arrange to have the wall-mounted water heater and the safety
»
group checked regularly by a qualified installer.
Check your fittings regularly. Remove limescale from the fitting
»
outlets with conventional scale removal products.
Freezingrisk
The unit is protected against freezing in all operating modes, ho-
wever the safety group and the water pipe are not.
energysavingtip
The heat content display allows you to obtain a hot water supply
which is optimum for you, energy-saving, and matched to suit
your usual consumption requirements.
Howtoproceed:
Start with a temperature setting of 65 °C. If, after the largest
draw-off (e.g. filling the bath), more than one LED lights up, red-
uce the temperature setting. By following this procedure, you will
determine the optimum low storage temperature for your usual
requirements, and so reduce possible heat losses to a minimum.
www.stieBel-eltrOn.cOm
A
sH s (gB)| 7