Special Information; General Information; Symbols In This Document; Test Mark - STIEBEL ELTRON SNU 10 Plus Manual

Special information

1 Special information
– The appliance may be used by children over
3 years of age and persons with reduced
physical, sensory or mental capabilities or a
lack of experience and expertise, provided
that they are supervised or they have been
instructed on how to use the appliance
safely and have understood the potential
risks. Children aged 3 to 8 years may only
operate the tap connected to the appliance.
Children must never play with the appli-
ance. Cleaning and user maintenance must
not be carried out by children without su-
pervision.
– When permanently connected to the power
supply using a dedicated junction box, the
appliance must be able to be isolated from
the mains power supply by an isolator that
disconnects all poles with at least 3 mm
contact separation.
– The power cable may only be replaced by
qualified contractors authorised by the
manufacturer. Use the original spare part.
Otherwise, you risk damaging the appli-
ance.
– Never connect the appliance via an external
switching facility such as a time switch.
– Secure the appliance as described in
chapter "Installation / Appliance installa-
tion".
– The appliance must only be installed with
an open (non-pressurised) tap.
– Never subject the appliance to water pres-
sure.
– The tap outlet has a vent function. Scale
build-up can block the outlet and subject
the appliance to pressure.
– Never block the tap outlet.
– Only use special aerators for non-pressur-
ised water heaters.
– Never extend the tap outlet with a hose.
2

General information

Read these instructions carefully before using the
appliance and retain them for future reference.
Pass on these instructions along with the appliance
as necessary.
12 | SNU 10 Plus
Information for Australia and New Zealand
This appliance must be installed in accordance with
the Plumbing Code of Australia (PCA) and the New
Zealand Building Code.
2.1

Symbols in this document

Symbol Meaning
This symbol indicates possible property damage, equip-
ment damage, consequential damage or environmental
damage.
General information is identified by the adjacent symbol.
This symbol indicates that you have to do something.

This symbol indicates that you must fulfil certain pre-

requisites before you perform the following steps.
 This symbol indicates a result or intermediate result.
These symbols indicate the software menu level (in this

example level 3).
This symbol indicates a reference to the corresponding
page number (page 11 in this example).
2.2

Test mark

See type plate on the appliance.
2.3

Units of measurement

All measurements are given in mm unless stated otherwise.
3

Safety

3.1

Structure of the warning notices

3.1.1 Section-specific warning notices
Section-specific warning notices apply to all steps in the section.
Injury
CAUTION
Type and source of risk
Consequence(s) of failure to observe the warning no-
tice
u Hazard prevention measure(s)
Property damage, consequential losses, environmental
pollution
Type and source of risk
Consequence(s) of failure to observe the warning no-
tice
Hazard prevention measure(s)
3.1.2 Embedded warning notices
Embedded warning notices apply only to the subsequent step.
u SIGNAL WORD: Consequence(s) of failure to observe the
warning notice. Hazard prevention measure(s). Step to
which the warning notice refers
3.1.3 Key to symbols
Symbol Type of risk
Injury
NOTICE
www.stiebel-eltron.com