Start-Up Procedure - FANATEC CSL Elite Racing Wheel Manual

IMPORTANT:
of wrong firmwares on the device! Do not try to force installation of any
wrong firmware to the product to avoid damages.
IMPORTANT:
Elite Racing Wheel has to be manually calibrated again. This is also indi-
cated by the LED display of the steering wheel showing 'CAL'. This warn-
ing will stop after manual calibration of the wheel center. See chapter
'Hotkeys'
IMPORTANT:
ed to the CSL Elite Racing Wheel has to be manually calibrated again. See
chapter 'Hotkeys'

7.2 Start-Up procedure

ATTENTION:
Racing Wheel is in progress never touch the attached steering wheel in
order to avoid injuries or incorrect calibration!
• Step1: Press the ON/OFF button "
the CSL Elite Racing Wheel, marked in the picture to the
right:
• Step2: The fans start working, the LED above the ON/OFF
Button "
• Step3: The CSL Elite Racing Wheel starts turning to the right side
(clockwise) until mechanical limit is reached. Then it runs back to the the
left side (counter clockwise) and stops.
▪
▪
28
Software measures protect the product from installation
After a firmware update, the center position of the CSL
'Wheel center calibration' for more details.
After a firmware update, the H-pattern shifters connect-
'Shifter calibration mode' for more details.
When initialization and auto calibration of the CSL Elite
" is lit red.
at the center position (0°) if wheel center was manually calibrated
before. Note: If SPR is set to low values or '000' the CSL Elite
Racing Wheel will stop in a different position after calibration run.
at about -60° on the left hand side if wheel center was not yet
calibrated (e.g. after firmware update; see description above in
this chapter).
" at the front plate of