Silicon Graphics Rackable H2106-G7 System User's Manual page 90

7: BIOS
Remote Access Configuration
Remote Access
Serial Port Number
Serial Port Mode
Flow Control
Redirection After BIOS POST
Terminal Type
Sredir Memory Display Delay
66
Use this option to Enable or Disable Remote Access in your system. If enabled, the settings below
will appear.
Use this setting to select the serial port for console redirection. Options include COM1, COM2 or
COM3*. The displayed base address and IRQ for the serial port changes to reflect the selection
you make. Note: Make sure the selected port is enabled.
Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8,n, 1), (38400 8, n, 1),
(19200 8, n, 1) and (09600 8, n, 1).
Selects the flow control to be used for console redirection. Options are None, Hardware and
Software.
Options are Disable (no redirection after BIOS POST), Boot Loader (redirection during POST and
during boot loader) and Always (redirection always active). Note that some OS's may not work
with this set to Always.
Selects the type of the target terminal. Options are ANSI, VT100 and VTUTF8.
Use this setting to set the delay in seconds to display memory information. Options are No Delay,
1 sec, 2 secs and 4 secs.
007-5683-004