Arris Touchstone TG3442 User Manual page 22

telephone provider must be removed and the wiring must be checked; there must
not be any voltage. Cancellation of telephone service is not adequate. Failure to do so
may result in loss of service or permanent damage to the Telephony Gateway.
1. Reset button: Resets the Telephony Gateway as if you power cycled the device. Use a
pointed non-metallic object to press this button.
2. Tel (1 - 2): Connectors for the phone lines.
3. USB: USB host connector. Future support for external USB devices.
4. Ethernet (1 - 4): Connectors for use with a computer LAN port.
5. Cable: Connector for the coaxial cable.
6. Power: Connector for the power cord.
Follow these steps to connect and turn on your Telephony Gateway:
1. Connect one end of the coax cable to the cable outlet or splitter, and the other end
to the Telephony Gateway's Cable connector. Tighten the connections by hand, then
tighten an additional 1/8 turn with a wrench.
Note: For best performance, use high-quality coax cable and minimize or
eliminate splitters between the cable jack and the Telephony Gateway.
2. Insert the plug from the power cord into the Power connector on the back of the
Telephony Gateway and insert the power cord into a convenient AC outlet.
Touchstone TG3442 Telephony Gateway User Guide STANDARD Revision 1.0
Chapter 3: Install and connect your Telephony Gateway
22