Riello Residence KIS Series Installer And User Manual page 16

RESIDENCE
- TIME ON, is displayed again, then the programming of the time bands
is resumed up to the maximum number of programmable bands (four),
Enter
or else
programming of the next day.
For each day of the week it is possible to programme up to 4 bands, each
one having a start time and an end time.
Outside these time bands, heat requests from the room thermostat are
ignored.
The central heating time bands enabled by default are:
When heating programming timing is enabled pressing the keys C+D allows
+
4.4
menu, as indicated in the paragraph "3.21 Access to the parameters" .
and arrows to scroll through the parameters of the pre-
pre-selected parameter with C and D
indicated by the icon .
Enter
Description of the settings menu
Some of the following functions might not be available depending on the
access level and the type of machine.
SETTING
TIME
From this menu the time and the number of the day of the week can be
adjusted.
TIME PROGRAM
From this menu you can access the menu for adjusting the heating
programming timing. For each day of the week it is possible to set up to 4
bands, characterised by a starting time and an end time.
It is possible to access the same menu directly from the main screen by
pressing the keys B+D at the same time for at least two seconds (see
paragraph "4.3 Time band scheduling function (room thermostat)")
16
+
C
D
RESET MENU
A; change the value of the
COMB
GAS TYPE
This parameter allows you to set the type of gas.
BOILER TYPE
Set this parameter for the type of boiler, see the relative paragraph "4.27
for more information.
COMBUSTION OFFSET
This parameter allows you to reset the factory settings of the combustion,
see the relative paragraph "4.28 Combustion Control Parameters" for
more information.
CONF
HYDRAULIC CONFIGURATION
boiler:
FLOWSWITCH
The factory setting for this parameter is 1, do not change! When replacing
the electronic board make sure that this parameter is set to 1.
WATER TRANSDUCER
This parameter allows you to set the type of water pressure transducer:
The factory setting for this parameter is 1, do not change! When replacing
the electronic board make sure that this parameter is set to 1.
AUTO WATER FILL ENABLE
installed.
The factory setting for this parameter is 0, do not change! When replacing
the electronic board make sure that this parameter is set to 0.
BEGIN SYSTEM FILLING
NOT AVAILABLE ON THIS MODEL
AIR PURGING CYCLE
This parameter allows you to disable the vent cycle function; the factory
setting is 1, set the parameter to 0 to disable the function.
MIN
This parameter allows you to change the minimum number of the fan's rpm.
Do not change!
MAX
This parameter allows you to change the maximum number of the fan's rpm.
Do not change!
MAX_CH
This parameter allows you to change the maximum number of the fan's rpm
in heating mode. Do not change!
RANGE RATED
This parameter allows you to change the heat output in heating mode, the
For more information about the use of this parameter see the paragraph
.