Connect To The Console Port; Access The Command-Line Interface - ADC MM701G User Manual

Connect to the Console Port

C
ONNECT TO THE
1 Install the flat gray console cable between the modem Console port and your PC as shown
below, using the DB-9 port adapter on the PC, if required.
PC
9-pin COM
port
A
CCESS THE
You can access the command-line interface through the direct connection to the modem console
port and using a terminal emulation program. You can also access the command-line interface
using a telnet session. To use a telnet session, you must have IP access to the modem either
through the 10Base-T LAN port (LAN-side access) or through an IP address assigned to a WAN
session (WAN-side access). The following sections provide instructions for setting up both
types of command-line interface access.
100
C
ONSOLE
Adapter
D S
Grey cable
C
OMMAND
P
ORT
L L
I N E
C O
N S
O L
E
1 0
B A
S E
- T
Console port
-L I
INE NTERFACE
P O
M D W E
I
M D R
I - X
MM701G and MM702G User Manual
M0326-A