Table of Contents
Advertisement
Configure the Remote LAN
1
Select
LAN
on the menu bar, then select
Configuration
2
In the
LAN Protocol
to bridged, it can be changed only through the command-line interface. See
"Accessing the Command-Line Interface"
the LAN protocol.
Any device (such as a PC) connecting to the modem LAN interface loses its
connection when the modem LAN IP address is changed. After the IP address
is changed, you need to specify this new address in the Web browser to
reconnect a device.
3
In the
IP Address
4
Click
Apply
.
MM701G and MM702G User Manual
page.
box, confirm that the protocol is set to
box, enter an available IP address on your subnet.
Chapter 7: Implementing a Point-to-Point LAN Extension
LAN Setup
under
LAN Options]
Bridged
for procedures on using this interface to change
to access the
LAN
. If the protocol is not set
Appendix
A,
69
Advertisement
Table of Contents
