Mitsubishi Electric E Series Data Book page 24

1. Product Specifications
Installing the fin guard
(1) Attach four types of frames to each position.
Frame 1
Panel
Screw down Frames 1 and 2 on the panel with M5 screws at
the four positions indicated with arrows in the figure.
* Screw down Frames 1 and 2 in the same way on the other
side.
(2) Attach the fin guards to four sides.
(3) Attach the plates according to the figure below.
Fix on the pipe for air-heat exchanger.
Fix the fin guards at the positions indicated with arrows in the figure with the supplied M5 screws. (Eight screws are used to fix
each fin guard.)
Attach the plates at the positions indicated with circles. (Seven plates are used for each fin guard.)
• In the case of two units
MEES19K040
Frame 2
Fin guard
Plate
Fix on the frame of fin guard.
Unit Unit
DT-150FG × 2
Frame 3
Screw down Frames 3 and 4 on the panel with M5 screws at
the six positions indicated with arrows in the figure.
* Screw down Frames 3 and 4 in the same way on the other
side.
or Unit Unit
DT-150FG × 1
Frame 4
Panel
Fin guard
23