Mitsubishi Electric E Series Data Book page 67

5. Wiring Design
Different types of switches on the PCB
[Control board]
Operation area 1
SWU1
Rotary switch SWU2
SWU3
SWP1
Push switch SWP2
SWP3
SW1-3
Dip switch
SW421
OFF ON
ON
1 2 3 4 5 6 7 8 9 10
MEES19K040
Rotary switch
(SWU2) (0-9)
Rotary switch
(SWU1) (0-9)
Push switch (SWP1)
Push switch (SWP2)
Operation area 2
Push switch (SWP3)
Sets the 10's digit of the unit address.
Sets the 1's digit of the unit address.
Use for switching the setting.
Use for increasing the setting value.
Use for decreasing the setting value.
Use for changing and deciding the setting value.
Select a setting which is decided with a combination of switch numbers.
Analog input type setting (Refer to Page 82 and 83)
Slide the dip switches:
do not push down the switches.
The figure at left shows that the switches 1 through 5 are set to ON and 6 through 10 are set to OFF.
[Enlarged the operation area 1]
Rotary switch
(SWU3) (0-F)
Dip switch (SW3)
Dip switch (SW2)
Dip switch (SW1)
[Enlarged the operation area 2]
LED display
Dip switch (SW421)
Initial Setting
MAIN circuit SUB circuit
"0" "5"
"1" "1"
"0" "0"
- -
- -
- -
- -
- (Unused)
66