The Engine Starting - VOGE 500DS User Manual

The engine starting

The side stand is laid down
Check if the engine cut of engine is located
at position " ".
Insert the key into the ignition switch and
turn to position "
Confirm the engine is on the neutral gear, the neutral indicator light "N" on instrument may be on.
When the conditions above equipped firmly grasp the clutch by left hand for ensuring the safety press
down the electrical starting button "
After the engine started keep the engine idling till completely pre heated
This model is with the interlocking design between ignition and starting circuit and the engine could be
only started under conditions below
– The engine is at the neutral gear both the ignition and engine cut at the position "
grasp the clutch lever for safety
– When gear is put in non-neutral gear N , the ignition switch and shut-off switch are kept in switching on
position.
– Pick up the side stand and firmly grasp the clutch lever
The colder the weather the longer time for pre heating is needed sufficient pre heating helps lubrication
and decreases the engine abrasion Idling for a long time is not allowed due to the poor heat radiation
may lead to engine overheat and damage
Under cold conditions for quick starting press the electrical starting button while suitably turn the
throttle grip .
The lubricant in engine only works only when engine is running. Push the motorcycle for a long distance
when the engine doesn't work is not allowed. After the engine started check if the indicator lights on the
instrument permanently on or flash in case it is stop the engine and make corresponding inspection
32
.
".
,
"
,
:
,
.
" "
,
.
,
,
The emission of motorcycle is with CO which is a gas
without smell and color but poisonous.
Long idling in the place without sound ventilation
is not allowed,for preventing poisoned.
by right hand without turning throttle lever.
.
!
Warning
-
.
,
,
!
Danger
- .
,
, -
,
,
" on, and firmly
.