Advertisement
3. Clean the pre-filter
Remove pre-filter from unit and clean with
vacuum cleaner, or wash in cold water.
4. Clean the 3-in-1 filter
Clean with vacuum cleaner without removing
from unit.
Do not apply pressure with vacuum cleaner, and do not damage the filter when
washing.
5. Install the pre-filter
Insert claws on both sides of pre-filter into holes on main unit.
＊Take care not to break the belts attached to the HEPA filter.
6. Attach the front cover
Fit the top of front cover into top of main unit and push both
sides in to lock lower hooks fully.
7. If you plug in and switch on and find the cleaning light
illuminated, push the reset button with a pin. When you
remove the pin, a sound is produced and the light extinguishes.
Do not push for over 5 seconds (otherwise
this changes filter replacement period)
Cleaning time varies with air quality, so periodic cleaning should be carried out.
Note
Filter reset button
14
3-in-1 filter
Advertisement
