Royal Enfield BULLET TRIALS 500 Owner's Manual page 44

WHEEL REMOVAL / ASSEMBLY
REAR WHEEL REMOVAL
Place the motorcycle on center

stand on a firm and flat surface.
Note the alignment index marks

in the both side of swing arm.
Remove wheel spindle from left

side as shown.
Remove the brake hose pipe from

the swing arm clips.
 Remove the caliper assembly with
bracket by pulling out from the
swing arm slot.
Place the wooden piece/card

board sheet in between the brake
pads.
Remove the left side spacer from

rear wheel hub.
Tilt motorcycle to right side and

slide out rear wheel.
REAR WHEEL REASSEMBLY
Ensure the four Cush rubbers

Index mark
are in position inside the rear
wheel hub.
 Tilt motorcycle to right side and
Swing Arm Reference
Mark
insert the wheel assembly
between the swing arms.
 Position the rear wheel with cush
rubber on the rear chain
sprocket.
Fix the left side spacer in rear

wheel hub.
 Remove the wooden piece / card
board sheet in between the
brake pads.
Insert the caliper assembly with

bracket by matching the slots
given in the caliper and swing
arm.
43
Caliper Slot