Basic Operation; Initial Power Up - Musicom Lab EFX-LE II Owner's Manual

2. BASIC OPERATION

2.1 Initial Power Up

The EFX-LE II requires a DC9V power supply.
When you power up the EFX-LE II, the LCD display will show the serial number, firmware and power test results.
And then the Page 1 of Bank 01(or Song 01), Preset 1 is selected.
2.2 Page 1
The EFX-LE II has 640 presets and 1 global preset that you can choose from, and they're arranged in banks of four.
When the EFX-LE II powers up, it selects Page 1, Preset 1 and Bank 1.
▼
Press/hold BANK or BANK
in the new bank.
① Press/hold the BANK ▼
or BANK
② The bank number on the LCD display will blink and the LEDs above P1 - P4 switches will turn off.
③ The preset is selected via pressing any switches from P1 through P4.
④ The bank number on the LCD display will stop blinking and the LED above the switch will be turned on in blue.
For example: to select the second preset of bank 3, press the BANK
shown on the LCD display. And then press the
The GLOBAL PRESET is a preset with all the capabilities of PRESET 1 through 4, but is the same for all banks.
Pressing the switch of a preset that is already on selects the global preset and will cause the LED above the switch to
be turned off. To enable/disable the Global Preset, refer to the PST 2nd PRESS on the page 30 of the manual.
SW #1 SW #2
Preset 1 Preset 2
* The Global.BPM changed by tapping the TAP switch is applied to the current bank or song. In other words, the
Preset.BPM stored in the current bank or song is ignored.
** Pressing/holding the #6 switch for 1 second will mute the guitar signal.
Pressing/holding the #6 switch for 1 second or press any switches from P1 through P4 switch will cancel the
MUTE function.
EFX-LE II Audio Controller Owner's Manual
• Line 1 - d to j indicate the serial number of your unit.
• Line 1 - m to p indicate the firmware version of your unit.
• Line 2 - m to p indicate the power test results.
• Line 1 - b to d indicate a bank number.
• Line 1 - e to p indicate the preset title of the current preset.
• Line 2 - a indicates a preset number within the current bank.
• Line 2 - c indicates a page number within the current preset.
• Line 2 - e to p indicate which of the IA switches are currently active.
▲
switch to shift other banks, pressing one of the four switches (P1
▲
switch to scroll through the 160 available banks.
P2
switch.
SW #3 SW #4
Preset 3 Preset 4
OK : Input Voltage is 8.2V~9.8V.
Low : Input Voltage is under 8.2V.
High : Input Voltage is over 9.8V.
▼ ▲
or BANK switch until the bank number 00
SW #5 SW #6
Tap Page Up
* **
Tempo( ) /Mute( )
–
P4) selects a preset
SW #7 SW #8
Bank Bank
Down Up
3
is
7