Electrical Safety - Black+Decker SVB520JW-B5 Manual

ENGLISH
Warning! Never attempt to replace the charger unit with a
regular mains plug.
• Use your BLACK+DECKER charger only to charge the
battery in the appliance with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
• Never attempt to charge nonrechargeable batteries.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
• The appliance/battery must be placed in a well
ventilated area when charging.

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
appliance.
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
The charging base is intended for indoor use only
Labels on appliance
The following symbols appear on this appliance along with
the date code
Read all of this manual carefully before using
the appliance
SVB520JW-B5 use charger JOD-S-220050BS,
BLJ15L220050P-B
JOD-S-220050BS
BLJ15L220050P-B
SVB620JW-B5 use charger JOD-S-270050BS,
BLJ15L270050P-B
JOD-S-270050BS
BLJ15L270050P-B
Features
This tool includes some or all of the following features.
1. Hand vac
2. On/Off power switch
3. State of charge/discharge indicator
4. Dust bowl release button
5. Dust bowl
6. Floor head
7. Floor head release button
6
(Original instructions)
8. Brush tool
8a. Brush tool storage recess
9. Crevice tool
9a. Crevice tool storage recess
10. Main body
11. Hand vac release button
12. Handle lock
13. Handle
14. Speed selection switch
15. Stick vac On/Off button
16. Charger
16a. Charger plug
17. Wall mount
Assembly (Fig. A, B, C)
• Raise the handle (13) to its operating position until it
locks into place. To lower the handle, twist the handle
lock (12) to the unlock position as shown in figure A.
• Align the bottom of the stick vac body (10) with the floor
head (6) as shown in figure B.
• Push the bottom of the stick vac body (10) onto the floor
head (6) so it locks into position as shown in figure B.
• To release the floor head from the stick vac body, press
the floorhead release button (7).
• Insert the hand vac (1) into the stick vac body (10) as
shown in figure C, ensuring it clicks firmly into place.
• To release the hand vac from the stick vac body, press
the hand vac release button (11).
Charging the battery (Fig. D, E)
From new, the rechargeable cells of the product need a
minimum charge time of 4 hours to ensure full power.
• Secure the wall mount (17) to a suitable surface near a
power outlet, as shown in figure D.
• The stick vac can be hung from the wall mount via the
hook (18) on the back of the handle while charging or
being stored.
• Plug the jack plug of the charger (16) into the charging
port (19) located on the stick vac body, as shown in
figure E.
• Plug the charger plug into the power source and switch
on, as shown in figure E.
• The LED (3) flashes red during normal charge and turns
green for 60 seconds once charged.
• Fast RED blink indicates a bad battery pack.
Please contact your BLACK+DECKER dealer.