Service & Technical Data; Troubleshooting - LifeFitness TREADMILL DESK Operation Manual

8
SERVICE AND TECHNICAL DATA

8.1 Troubleshooting

Problem
The Treadmill Desk does not
turn on when the ON/OFF
switch is turned on.
The GO button is lit and
blinking. All other displays are
blank / off.
The Treadmill Desk shakes a
lot when I walk on it.
The belt is tracking to the left
or right.
The belt seems to slip when I
walk on it.
I am having problems bolting
the parts together when as-
sembling the unit.
"-------" is displayed on the
console.
" "
is displayed on the console.
16
Cause / Solution
You may be in "Energy Saver Mode". Press the GO button to see if the user controls
turn on.
Check to see if the Treadmill Desk is plugged in and if the ON/OFF switch is on. If the
ON/OFF switch is on, verify that the Treadmill Desk power cord is not damaged and
the wall outlet is functioning (tripped breaker).
If the ON/OFF switch is on verify that all the customer assembly connections are work-
ing properly. Unplug and re-plug each connection to verify. Look to see if any of the
cables were pinched during assembly.
You are in "Energy Saver Mode". Press the GO button to wake up the user controls.
1. Turn the Treadmill Desk OFF. Make sure all assembly hardware is tightened.
2. If shaking still occurs, adjust the levelers under the stationary frame until the shak-
ing decreases. See How to Stabilize the Treadmill Desk (Section 3).
See How to Adjust and Tension the Walking Belt (Section 8.3).
You may need to tighten the walking belt. See How to Adjust and Tension the Walk-
ing Belt (Section 8.3).
1. Do not fully tighten the screws until the crossbar, desktop, and uprights are all
installed.
2. Check the screw threads for any damage.
This message is displayed if the Emergency Stop magnet is not in place.
Place the magnet back in position.
This message appears in the Time display when the unit is immobilized. Press and
hold both the SPEED DOWN ARROW and the PAUSE keys on the integrated user
controls to mobilize the Treadmill Desk.