Restoring Site Data; Restoring Site Data From A Pc Card; Pc Card Restore Error Messages - NEC DS2000 Hardware Manual

Restoring Site Data

Restoring Site Data

Restoring Site Data from a PC Card

To use the PC Card to restore site data:
1. Insert the PC Card into the CPU (See Using the PC Card on page 5-3).
2. Be sure the CPU mode switch is set to RUN.
3. Enter the programming mode.
4. Dial 9907 + HOLD.
5. Dial Y + HOLD.
6. Press VOL
7. When the data base you want to restore displays, press HOLD.

PC Card Restore Error Messages

NO PCCARD
NO DATABASE
5-4 Section 5: Maintenance Options and SMDR
Review PC Card Data Base Compatibility on page 5-1.
ICM + #*#* + 372000 + HOLD
You see: START?
You see the name and date of the first database stored. If no data bases are stored, you see:
9907: DB00
(empty)
or VOL to scroll through the data base addresses and select the one you want to restore.
In software versions 02.00.01 and higher, there are 16 data base addresses: DB 00 to DB 15.
The PC Card Active LED is on during restore.
You automatically exit programming when the upload completes.
PC Card Restore Error Messages
This error message: Means this:
The PC card is not installed. Install the PC
card and try again.
There is no data stored in the data base address
you selected. Select another data base address
and try again.
DS2000 Hardware Manual