Music Source; Installing A Music Source; Programming Background Music; Programming Music On Hold - NEC DS2000 Hardware Manual

Hide thumbs Also See for DS2000:
Table of Contents

Advertisement

Music Source

Music Source

Installing a Music Source

Your system provides connection for a customer provided music source. Use this music source for Back-
ground Music and Music on Hold.
Be sure the connected music source is compatible with the following music input specifications:
The following products should help if you make your own cables. The connector is generally referred to as a
RJ45 connector wired in an RJ61X configuration. Check with your local supplier for comparable products.
Suttle SE-266-8K 8 Position Modular Plug (requires an SE-166 or SE-166-6 modular crimping tool).
Hubbell BRFT4P Snap-On 8 Position Modular Plug (does not require a special crimping tool).
To connect a music source (Figure 4-5):
1.
Find an available connector in a station cable and make sure it is correctly punched down at the
66M1-50 block.
2.
For the connector chosen, locate pins 2T and 2R and connect the music source.
3.
Plug the modular jack into the CPU modular connector.
Latch
faces up

Programming Background Music

In 0201 - Background Music, enter Y to enable Background Music system-wide.
In 1802 - BGM, enter Y to enable Background Music at the extension.
To turn Background Music on and off:
1.
Do not lift the handset or press SPK.
2.
Press HOLD.

Programming Music on Hold

In 0201 - Music on Hold, enter Y to enable Music on Hold system-wide.
In 0201 - MOH on Transfer, enter Y to enable Music on Hold for transferred calls.
4-6
Section 4: Optional Equipment
Input Impedance
Output Level:
Follow standard color code order. Be sure the block is properly cross-connected.
RJ61X
Port
To CPU
Pin
Designation
Mod Jack
1
4T
2
3T
3
2T
4
1R
5
1T
6
2R
7
3R
8
4R
80000 - 18A
Note
reversal
Figure 4-5: Installing a Music Source
Music Input Specifications
+18 dBr (+2 dBr) @ 1.0 KHz
To 66 Block
WHT-BLU (1T)
BLU-WHT (1R)
WHT-ORN (2T)
ORN-WHT (2R)
WHT-GRN (3T)
GRN-WHT (3R)
WHT-BRN (4T)
BRN-WHT (4R)
10K Ohms
Page Out
Music In
Relay Contacts
No Connection
DS2000 Hardware Manual

Advertisement

Table of Contents
loading

Table of Contents