FUTABA FASSTest-2.4GHz T18SZ Series Instruction Manual page 15

How to turn transmitter power ON/OFF
When turning on the power, the T18SZ transmitter will begin emmiting RF automatically after it
confirms the surrounding RF conditions. The status of the transmitter is displayed by LED at the upper
part of the front of a T18SZ.
Power ON
Throttle Stick Slow
If the power switches are turned off in the opposite order the model may unexpectedly run out of control and
cause a very dangerous situation.
Turning on the power switches
1. Turn on the transmitter power switch.
2. Turn on the receiver or speed control power switch.
ON
Stick control
Aileron stick
Engine /motor
Power
Throttle stick
*If THR stick is high, the next WARNING screen will come out. Moreover, if a power
supply is switched on while SW set by WARNING setup has been ON, it will be
indicated by WARNING.
Power Switch
Right Push
ON
Roll axis
Power OFF
Power Switch
Right and Left Push
Turning off the power switches
Always be sure the motor/engine is stopped.
1. Turn off the receiver or speed control power switch.
2. Then turn off the transmitter power switch.
OFF
Yawing axis
Rudder stick
Power Switch
or
Right or Left Long Push
OFF
Elevator Stick
Pitching axis
<Before Use> 15