FUTABA FASSTest-2.4GHz T18SZ Series Instruction Manual page 8

LiFe/NiMH/NiCd Battery Safety and Handling instructions
IMPORTANT!
Use only the Futaba special charger included with this set or other chargers approved
by Futaba to charge the LiFe batteries in the T18SZ transmitter included with this set.
It is important to understand the operating characteristics of LiFe/NiMH/NiCd batteries.Always
read the specifications printed on the label of your LiFe/NiMH/NiCd battery and charger prior to
use. Failure to follow the proceeding precautions can quickly result in severe, permanent damage
to the batteries and its surroundings and possibly result in a FIRE!
IMPORTANT PRECAUTIONS
Do not attempt to disassemble LiFe/NiMH/NiCd packs or cells.
Do not allow LiFe/NiMH/NiCd cells to come in contact with moisture or water at any time.
Always provide adequate ventilation around LiFe/NiMH/NiCd batteries during charge, discharge,
while in use, and during storage.
Do not leave a LiFe/NiMH/NiCd battery unattended at any time while being charged or discharged.
Do not attempt to charge LiFe/NiMH/NiCd batteries with a charger that is NOT designed for LiFe/
NiMH/NiCd batteries, as permanent damage to the battery and charger could result.
Always charge LiFe/NiMH/NiCd batteries in a fireproof location. Do not charge or discharge LiFe/
NiMH/NiCd batteries on carpet, a cluttered workbench, near paper, plastic, vinyl, leather or wood,
or inside an R/C model or full-sized automobile! Monitor the charge area with a smoke or fire alarm.
Do not charge LiFe/NiMH/NiCd batteries at currents greater than the "1C" rating of the battery ("C"
equals the rated capacity of the battery).
Do not allow LiFe/NiMH/NiCd cells to overheat at any time! Cells which reach greater than 140
degrees Fahrenheit (60°C) should be placed in a fireproof location.
LiFe/NiMH/NiCd cells will not charge fully when too cold or show full charge.
It is normal for the batteries to become warm during charging, but if the charger or battery becomes
excessively hot disconnect the battery from the charger immediately!! Always inspect a battery which
has previously overheated for potential damage, and do not re-use if you suspect it has been damaged in
any way.
Do not use a LiFe/NiMH/NiCd battery if you suspect physical damage has occurred to the pack.
Carefully inspect the battery for even the smallest of dents, cracks, splits, punctures or damage to the
wiring and connectors.
DO NOT allow the battery's internal electrolyte to get into eyes or on skin—wash affected areas
immediately if they come in contact with the electrolyte. If in doubt, place the battery in a fire-proof
location for at least 30 minutes.
Do not store batteries near an open flame or heater.
Do not discharge LiFe/NiMH/NiCd batteries at currents which exceed the discharge current rating of
the battery.
Always store LiFe/NiMH/NiCd cells/packs in a secure location away from children.
Secure Digital (SD) Memory Card Handling Instructions
Never remove the SD card or turn off power
while entering data.
Never store the SD card where it may be
subject to strong static electricity or magnetic
fields.
Do not expose the SD card to direct sunlight,
excessive humidity or corrosive environments.
8 <Introduction>
(SD card is not included with this set)
Do not expose the SD card to dirt, moisture,
water or fluids of any kind.
Always hold the SD card by the edges during
installation and removal.
Be certain to insert the SD card in the correct
direction.