Advertisement
4
Installing the Spray Gun
Parts needed for this procedure:
1
Hose, long
1
O-ring, small clear
1
Spray gun
1
Hose clamp, small
Procedure
1. Locate the small, clear O-ring in loose parts and
lubricate it using a non-petroleum based lubricant
such as vegetable oil. Install the O-ring between the
long hose and control valve assembly (Figure 9).
2. Connect the threaded fitting on the end of the long
hose to the control valve assembly (Figure 9).
3. Remove any plugs in the free end of the hose. Then
connect the long hose to the fitting on the gun
(Figure 10).
Figure 10
1. Spray gun
2. Hose fitting
4. Secure the end of the hose with a small hose clamp.
5. Wrap the hose around the hooks on the tank and
place the spray gun in the gun bracket.
1
2
3
G005787
3. Hose
5
Installing the Rinse Tank
Bulkhead Fitting
Parts needed for this procedure:
1
Bulkhead
1
Plastic ring nut
Procedure
1. Remove the fastener securing the right side of the
front tank strap to the main tank assembly.
Note: Retain all parts and fasteners.
2. Lift the front tank strap and remove the rinse tank
(Figure 11). Remove the cap from the rinse tank
and retain.
2
1
4
5
6
1. Rinse tank
2. Main tank
3. Front strap
4. Bolt
3. Turn the rinse tank upside down and locate the drill
point in tank sump area.
4. Drill a hole in the sump of the rinse tank using a 5.4
cm (2-1/8 inch) hole saw.
Important: Do not elongate the opening. An
elongated opening will not be sealed correctly
by the bulkhead fitting yet to be installed and
the rinse system will leak.
5. Use a blade to clean the plastic burrs and excess
material from the drilled hole.
7
7
3
G005788
Figure 11
5. Washer
6. Lock nut
7. Cap, rinse tank
Advertisement
