Advertisement
23
Installing the Pressure Tap
Parts needed for this procedure:
1
Straight fitting, brass
1
Tee fitting, metal
1
Pipe plug
Procedure
1. At the center of the valve manifold, between the
main tank and the manifold, locate the pressure
tap and line. The line is routed and connected to
the reducer fitting on the pressure gauge that was
previously installed. Disconnect the pressure tap
and retain.
2. Locate the small, brass straight fitting connector, the
metal tee fitting and pipe plug fitting in loose parts
(Figure 57). Wrap Teflon tap around the exposed
threads on all fittings.
G005909
3
Figure 57
1. Valve manifold, opening
2. Reducer fitting, from
pressure gauge
3. Straight fitting, brass
3. Install the brass straight fitting connector to the
opening in the valve manifold where the pressure tap
was removed previously (Figure 57).
4. Install the metal tee fitting to the exposed end of
the brass straight fitting. Use the center port on the
metal tee fitting (Figure 57). Install the wrapped pipe
plug fitting to the open end of the metal tee fitting
that faces to the left side of the machine.
5. Wrap the threads of the existing pressure line
removed previously and install it to the remaining
opening in the metal tee fitting (Figure 57).
1
5
4
2
4. Metal tee
5. Pipe plug
24
Installing the Decal
Parts needed for this procedure:
1
Decal 112-7906
Procedure
1. Locate the decal in loose parts. Thoroughly clean
the area on the plastic fender above the left, front
wheel (Figure 58).
1
2
1. Plastic fender, above left,
front wheel
2. Dampen the area with water or mildly soapy water.
3. Peel the decal from the backing and install the decal
as shown in Figure 58.
4. Squeegee across the surface of the decal, starting
at the center of the decal and working toward the
edges, using overlapping strokes.
27
G005878
Figure 58
2. Decal, 112–7906
Advertisement
