Advertisement
the retainer fork and disconnect this existing hose.
Retain the large fork at this location for later use.
2. Follow this hose until it terminates on the left side
of the valve manifold. This hose is connected to
the side of the valve manifold facing to the front of
the machine (Figure 55). Loosen the hose clamp
securing the hose and disconnect it from the barb
on the valve manifold. Discard this hose and retain
the hose clamp.
G005904
Figure 55
1. Left side of valve manifold
3. Locate filter supply hose in loose parts (Figure 1). It
has a 70 degree fitting on one end and a 90 degree
fitting on the other end.
4. Install the 70 degree fitting on this hose to the
open port on the top of the pressure filter installed
previously. Use the plastic nut on the fitting to secure
the hose to the pressure filter (Figure 56).
2
1
2. Boom supply hose,
terminating
G005905
1
1. Filter supply hose
2. Rinse valve, vertical
5. Route the remaining end to the vertically orientated
rinse valve on the control valve assembly. Install
the 90 degree fitting to the open port on the rinse
valve and use the existing large fork to secure the
connection (Figure 56).
6. Locate manifold supply hose in loose parts
(Figure 1). It has a 70 degree fitting on one end and
is open on the other end.
7. Install the 70 degree fitting on this hose to the
remaining, open port on the side of the pressure
filter facing toward the front of the machine. Use
the plastic nut on the fitting to secure the hose to
the pressure filter.
8. Route the open end from the pressure filter to the
left side of the machine between the main tank and
the valve manifold.
9. Slide the hose clamp removed previously over the
open end of the hose and install the open end onto
the open hose barb on the left side of the valve
manifold. Use the hose clamp to secure the hose to
the valve manifold.
Important: Upon completion of securing the hose
fittings, check to see that all hose are not kinking
or are twisted. If a hose shows signs of torsion,
loosen the metal hose clamp securing the hose to
the fitting. Rotate the hose on the fitting until the
stress on the hose is relieved. Tighten the metal
hose clamp.
26
3
2
4
Figure 56
3. 70 degree fitting
4. 90 degree fitting
Advertisement
