Advertisement
disconnect this end of the bypass hose (Figure 51).
Retain the medium fork at this location for later use.
2
1. Bypass hose, existing
2. Large fork
4. Remove the bypass hose from the tank underside.
5. Locate the tee connection in loose parts. Remove
the retainer forks.
3
1
4
G005898
Figure 51
3. Tank drain, installed
previously
4. Retainer fork, medium
6. Locate the filter flush hose coming from the bottom
of the pressure filter assembly installed previously.
Install the open 90 degree fitting from this hose to
the middle connection of the tee (Figure 52). Use a
small retainer fork to secure the connection. Leave
the tee fitting laying on the fender of the right, rear
wheel.
G005899
4
3
1. Right, rear fender
2. Tee connection
24
1
2
2
Figure 52
3. Filter flush hose, from
pressure filter
4. Pressure filter
Advertisement
