Advertisement
7. Locate bypass hose in loose parts (Figure 1).
Connect the 90 degree fitting to the open connection
on the right side of the valve manifold, see Figure 50,
and secure it with the existing, small retainer fork.
Route the bypass hose under the existing agitation
hose to the tee connection on the fender (Figure 53).
G005902
1
2
1. Bypass hose
2. Agitation hose, existing
8. Connect the opposing end of the hose with the
straight connector to the open side of the tee fitting
that is facing to the back of the machine. Use a
small retainer fork from loose parts to secure the
connection (Figure 53).
9. Locate tank return hose in loose parts (Figure 1).
Under the machine, locate the opening where the
original bypass hose was disconnected (Figure 51).
Install the 90 degree fitting at this opening and use
the existing large fork to secure the connection.
10. Route the remainder of the hose with a straight
fitting out from under the tank, above the frame.
The hose should lay over the right, rear fender point
toward the rear of the machine. Lower the tank and
make sure the hose is not being pinched.
11. Install the end of the hose with the straight fitting
to the open connection on the tee fitting facing
to the front of the machine (Figure 54). Use the
3
3
Figure 53
3. Tee connection
small retainer fork on the tee fitting to secure the
connection.
G005903
1. Tank return hose
12. Tight the retaining bolts on the right side of the
machine at both front and rear tank straps.
Important: Make sure the tank and frame does
not pinch the hose when tightening the retain
bolts on the tank straps. If so, adjust the hose
position before continuing.
22
Installing the Pressure Filter
Hoses
Parts needed for this procedure:
1
Filter supply hose
1
Manifold supply hose
Procedure
1. At the control valve assembly on the right side and to
the rear of the tank. Locate the rinse valve installed
vertically during the installation of the Rinse Kit.
Locate the existing boom supply hose that comes
from the this control valve and is routed between
the main tank and the valve manifold. Remove
25
2
Figure 54
2. Tee connection
1
1
Advertisement
