Advertisement
Figure 28
1. Vehicle frame
2. Bolt (5/16 x 3/4 inch)
3. Tire, left front
3. Drill a hole, 16 mm (5/8 inch) in diameter, in the
dash panel. The hole should be 23 cm (9 inches)
to the left of the steering column base and 5 cm (2
inches) from the top of the dash (Figure 29).
2
1
Figure 29
1. Drill hole here
2. Dash
Note: Do not install the horn button at this time.
4. Horn
5. Locknut (5/16 inch)
3
3
G002961
3. Steering column
11
Applying the Horn Decal
Parts needed for this procedure:
1
Decal 104-6957, horn
Procedure
Install the horn decal above the dash hole.
1. Clean the decal area above the horn button hole and
make sure it is free of dirt, grease, or other foreign
material.
2. Remove the backing of the new decal and place
about 6.5 mm (1/4 inch) above the horn button on
the dash (Figure 30).
1. Horn
15
Figure 30
Advertisement
