Table of Contents
Advertisement
6. Launch HeartSine Gateway
Configuration Tool.
7. Click the right arrow to proceed.
NOTE Your PC / laptop will disconnect from the Wi-Fi network to connect to HeartSine
Gateway. When HeartSine Gateway has been configured, you may need to reconnect your
PC/laptop to your Wi-Fi network.
8. As shown on the screen, place HeartSine
Gateway into set-up mode by pressing
and holding the POWER button for
approximately six seconds until the status
indicator turns solid blue. You can only
connect one HeartSine Gateway at a time.
(Further information on the LED status
indicator can be found in Appendix 3.)
21
Advertisement
Table of Contents
